Ncomputing PC Expanion L120 Manuel d'utilisateur télécharger pdf (Page 59)

8-18

In order to save the changed option, the PC Expanion must be restarted.

Click the <Yes> button in order to restart the PC Expanion.

󳃨

󳃐

If the PC Expanion is currently being connected and used, a warning

message appears. If you click the <Yes> button, the PC Expanion

restarts. However, since the current environment settings are

unchanged, you can use your environment settings when you

logon with the same user account after restarting.

Note

󳃐

If the PC Expanion is turned off or does not exist in the same sub-

network, the following screen appears and the settings will not be

changed. In this case, click the <OK> button to cancel the changes.

When the PC Expanion is rebooted, the PC Expanion attempts to

connect to the specific host PC after a few seconds. If the PC Expanion is

connected to the host PC, please check the IP address of the specific

host PC in the setup.

PC Expanion users can log in from the host PC. <Start> ▶ <All

Programs> ▶ <NCT-2000-XP> ▶ Select <NCT-2000-XP Console>

in order to run the NCT-2000-XP program. Go to <Hardware

Settings (Local/LAN)> ▶ Select <UTMA/UTSA Device> and then

select the specific PC Expanion. Then double-click it.

8. How to log in automatically when the PC

Expanion connects to the host PC.

Click the <Connection Settings> icon

in the ‘UTMA/UTSA Setup view’.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 97 98

Pas de commentaire

Ncomputing PC Expanion L120 Manuel d'utilisateur Page 59